DK65S engine side panel

[Husaberger]

I was looking back while mowing and didnt see that the left/driver's engine side panel fell off

I ran over it with my mower and it is now unfixable

Have called all of the salvage yards I have been able to find online with no luck

Anyone out there happen to have a spare?

If not, does anyone out there have an illustrated parts breakdown for a DK65S?

Looks like Kioti doesn't offer what I am used to finding on the Kubota website

 

[ptsg]

Check here for the part numbers:

Parts Finder Michigan Iron & Equipment Morrice, MI (855) 265-4590

Parts Finder Michigan Iron & Equipment Morrice, MI (855) 265-4590

www.michiganironandequip.com

Michigan Iron Equip has the parts catalogue online. Great resource to have.

You can then figure out the part numbers and shop around.

 

[Husaberger]

Check here for the part numbers:

Parts Finder Michigan Iron & Equipment Morrice, MI (855) 265-4590

Parts Finder Michigan Iron & Equipment Morrice, MI (855) 265-4590

www.michiganironandequip.com

Michigan Iron Equip has the parts catalogue online. Great resource to have.

You can then figure out the part numbers and shop around.

Thanks ptsg

Looking at those prices, I guess my questions are narrowed down to one

Does anyone happen to have a spare?

 

[ptsg]

This one seems a bit more affordable though: Kioti OEM T4816-50753 Cover(Lh),Side

Just the side panel, still missing some other bits and pieces.

 

[Husaberger]

This one seems a bit more affordable though: Kioti OEM T4816-50753 Cover(Lh),Side

Just the side panel, still missing some other bits and pieces.

Thanks again ptsg

What kind of lathe and where in PT?

 

[ptsg]

Thanks again ptsg

What kind of lathe and where in PT?

I'm near Leiria, about 80-ish miles north of Lisbon.

This is an Italian made Giana 230 lathe. Not much info online about it though but it's a 510 mm x 1500mm (20" x 60"). It has a raised headstock, tailstock and tailstock ways, so it gives extra clearance to swing bigger parts.

 

[caver]

One side fell off my DK40 last year and I ran over it before I realized what was making that odd noise. It was my own fault. I had partially put the side cover back on but got distracted. I hammered the worst out with a rubber mallet and hammer. Thankfully I wasn't mowing.