OP
jake98
Veteran Member
- Joined
- Nov 10, 2007
- Messages
- 1,881
- Location
- Dingmans Ferry PA
- Tractor
- 53 Cub, 70's JD 410, Kioti 25hst
Here's the good the bad and the ugly. 
I failed plasma cutting, shield set too dark, tried to find my way blind (never a good idea..) and wasn't able to get quite thru. Buggered up section will get milled out for wrench space. Tomorrow I'm going to see if I can mill the edge round, and recess the top to fit the inside of the chuck back.
I failed plasma cutting, shield set too dark, tried to find my way blind (never a good idea..) and wasn't able to get quite thru. Buggered up section will get milled out for wrench space. Tomorrow I'm going to see if I can mill the edge round, and recess the top to fit the inside of the chuck back.
