OP
blenderbender
Member
Thanks..... guess that's the fix I need to research next.
Draft control bleed off
- Thread starter blenderbender
- Start date
- Views: 1534
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,995
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Then the needle valve isn't seating properly and must be removed and cleaned. It does open and close Right? Sometimes the linkage from the seat pan to the valve corrodes and becomes inoperative. I use mine all the time depending on the weight of the implement on the 3PH to control the drop rate. It has no effect on the raising of the 3PH, only the drop.
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,995
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
I'd start by cleaning the needle valve as that is the less intrusive way to go.
ptsg
Super Member
Think about it. The flow control valve will only hold the cylinder if fully closed. If it's not fully closed, the position control valve holds the 3 pt in position set by the lever.
If the flow control valve is closed and the 3 pt still drops, then the issue is bad seals on the piston. Even if it wasn't fully seated as you say (extremely unlikely to happen), the cylinder wouldn't drop as long as it had good seals.
OP
blenderbender
Member
OP
blenderbender
Member
Dang.... I was hoping for the easier fix.
