easy change system

[rope1]

I've never seen this quick hitch up close, so I just wondered what kept the arms from sliding off the end of the pins. The pictures in the advertising don't show anything that will hold them together

 

[Ben_W]

I called the company and they said it would work with the 3 inches of straight arm length that my tractor has. Yours should be fine. Ben

 

[KirkMcD]

</font><font color="blue" class="small">( I've never seen this quick hitch up close, so I just wondered what kept the arms from sliding off the end of the pins. The pictures in the advertising don't show anything that will hold them together )</font>

The same pin that keeps the 3ph arms from falling off the attachment.

 

[milkman]

rope1
Here's what one looks like close up, maybe you can tell something by the pic.

 

[milkman]

The first pic is with the latch open, the easy change comes with the washers that are held on by the lynch pins.

 

[DannyD]

I have the system on my 23, and with the exception of all the adjusting screws and the ubolts, mine is the same as everyone elses. I have found that these items may not be needed as much as it seems. I have only the pins going thru the sockets in my lift arms, now everything fits without adjusting anything. Your lift arms are not at the same angle for a 48" tiller as they are for your other implements and with all the set screws I found that they were not "square" all the time, dont have that prob now.

Pats is great, especially on the CUTS and SCUTS.