Electrical Connector domestic vender help!

[jaydee325]

These guys specialize in mostly motorcycle electrical supplies but might be a shot.

Main

 

[lostcreekranch]

Eric;

Perhaps you cut the odd ball connector off and replace with a set of these square trailer connectors?

https://www.etrailer.com/Wiring/Hopkins/37995.html

Added: Under $6 for both sides of plug.

Sent from my iPad using TractorByNet

 

[hr3]

Why not use 6 wires with male tangs on their ends to connect to the other female tangs.

Good idea Skyhook....

 

[CCWKen]

Before I'd spend bucks on trying to match that plug, I'd buy a 6-pin Molex male and female and cut that dang thing off! :dance1:

Added: Here's Weatherpack pair for under $7. Weather Pack 6 Pin Sealed Wiring Connector Kit - HiPo Parts Garage

 

[MossRoad]

If he cuts anything off the seat, he can't return it if it doesn't work out as a comfortable seat....

 

[s219]

Why not use 6 wires with male tangs on their ends to connect to the other female tangs.

That's what I would do, and one benefit in this case is that you can most likely slide the blades out of that plug pretty easily without breaking anything. So you could put back to normal if the seat needs to be returned. Normally you can use a thin awl or probe/pick to release the locking tabs holding the blades in, and they will slide out easily.

 

[MinnesotaEric]

Thanks guys. As it is, I'm paying the shipping and restocking fee and sending the Grammer seat back.

 

[arkydog]

be sure to use dielectric grease.

 

[Steave]

If you still have your seat here's another # to check from mousers.
571-480003-5 $1.09 + 7.99 shipping ups.

 

[MinnesotaEric]

If you still have your seat here's another # to check from mousers.
571-480003-5 $1.09 + 7.99 shipping ups.

That sure looks like the plug. The seat isn't going to work out for me and I plan to return the seat on Thursday. Even so, thank you for your leg-work!