Mark @ Everlast
Advertiser
They are listed on our site. I don't think the 160sth is updated but you can figure its a little less than halfway between the 140 and the 200 DC amp units...But these list the Inrush Max for the units on stick since this is higher than TIG, and is what the units should be sized for according to code for safety. All the rest should be there that you may be interested in.
Here's a listing of them. Scroll down to the bottom of the page. This is our "details page" for our 185, but the same specs are repeated throughout every unit for side by side comparison. Also here is the link to the 140ST and 160STH on our site which are TIG units, but fit in our PowerArc category as a primary stick welder.
http://www.everlastgenerators.com/PowerTig-185-Micro-3910-pd.html
http://www.everlastgenerators.com/PowerArc-140ST-3915-pd.html
Here's a listing of them. Scroll down to the bottom of the page. This is our "details page" for our 185, but the same specs are repeated throughout every unit for side by side comparison. Also here is the link to the 140ST and 160STH on our site which are TIG units, but fit in our PowerArc category as a primary stick welder.
http://www.everlastgenerators.com/PowerTig-185-Micro-3910-pd.html
http://www.everlastgenerators.com/PowerArc-140ST-3915-pd.html
