Finally made grab bar for m59

Hersheyfarm · Mar 10, 2013

You can tell Kubota left provisions for one but don't offer it. This runs over top of the flat spot on the fender incase I want to run it down, but its sturdy enough to swing on so no need now. I was starting to make the console loose from grabbing it.

Mike1369 · Mar 10, 2013

You might want to put a rubber end cap so you don't rip out your kidney if you get out too quickly

creekbend · Mar 10, 2013

Nice job.:thumbsup:

Hersheyfarm · Mar 10, 2013

Mike1369 said:
You might want to put a rubber end cap so you don't rip out your kidney if you get out too quickly

Lol, I'm going to close the end up if I don't run to fender. I never enter/exit on this side bit having a handle makes it easier.

As I think about it this grab bar is close to you because of height, to clear console. I bet Kubota killed the ideal because if you roll it body parts could get underneath. The bar on other fender is low and of less hazard.