Firewood processor project.

   / Firewood processor project. #92  
I did built them. There is a lot of things that need improvement though! But after all I am satisfied with that 1st prototype.
I have processed a total of about 35 cords. I need about 1:45 hours for each cord start to finish, which includes the time with the tractor to load the deck, a possible reinstallation of the conveyor chain (my outfeed conveyor really sucks) plus some refuel.

Here are 2 small timelapses I have posted. But if you guys need more videos, I have a ton of them.
A short timelapse of the firewood... - Karamousadakis Emmanouil | Facebook
A better point of view :) - Karamousadakis Emmanouil | Facebook

Congrats on your built! It looks awesome! :)
 
   / Firewood processor project. #94  
I did built them. There is a lot of things that need improvement though! But after all I am satisfied with that 1st prototype.
I have processed a total of about 35 cords. I need about 1:45 hours for each cord start to finish, which includes the time with the tractor to load the deck, a possible reinstallation of the conveyor chain (my outfeed conveyor really sucks) plus some refuel.

Here are 2 small timelapses I have posted. But if you guys need more videos, I have a ton of them.
A short timelapse of the firewood... - Karamousadakis Emmanouil | Facebook
A better point of view :) - Karamousadakis Emmanouil | Facebook

Congrats on your built! It looks awesome! :)

I like it but it looks like your hand is in harms way an awful lot. I would like to see it in real time.
 
   / Firewood processor project. #95  
I like it but it looks like your hand is in harms way an awful lot. I would like to see it in real time.
I agree that a protective sheet should be next to the controls to protect my right hand and my face in case the chain breaks or gets off the bar. It actually happend :) The chain got off and spinned in front of my hand, no harm was made but it was scary.. A barrier is also needed because some chips bounce here and there. The whole "protection" subject needs some work in the next version



Check it
, thats a better angle.
 
   / Firewood processor project. #98  
Curiously, how do you get the logs on to the feed belt?

The plan is to make a feed table where the logs will be lifted with a tractor.
 

Tractor & Equipment Auctions

2016 Chevrolet Cruze LS Sedan (A44572)
2016 Chevrolet...
2007 Chevrolet Silverado 1500 Ext. Cab Pickup Truck (A44572)
2007 Chevrolet...
2012 KENWORTH T800 MID-ROOF SLEEPER (INOPERABLE) (A45333)
2012 KENWORTH T800...
2016 Ford Fusion S Sedan (A44572)
2016 Ford Fusion S...
100 Gallon Diesel Tank (A47369)
100 Gallon Diesel...
2015 Ford F-550 4x4 Ext. Cab Knapheide Service Truck (A44571)
2015 Ford F-550...
 
Top