Frontend Loader Mounts
- Thread starter TooCheap
- Start date
- Views: 2589
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 24,646
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
If you just bought this loader...or even bought it used, I'd contact Great Bend and see what they say.
It's possible they have the mounts, or at least have the dimensional requirements (after all, they did build the loader).
Good luck!
It's possible they have the mounts, or at least have the dimensional requirements (after all, they did build the loader).
Good luck!
rdbigfarmboy
Gold Member
Can you post pics of the tractor and loader. Most loaders attached to the frame about the bell housing and to the front end above the front axle. I know there are 3 versions of the 574. I just put a CIH 2250 loader made for something like your tractor on to a Foton (tractor king) 704 tractor. mine works well but took some deciphering.
Attachments
kayssupply
Platinum Member
Great Bend was purchased by Bush Hog. If you go to the Bush Hog site there are links to Great Bend.
MMM
Platinum Member
Helps to know what tractor it came off of. How's the width comparison? Usually some fabbing will be needed unless loader is made for a particular series of tractor (74,84,85,95). I put a Ford industrial loader on a Case by putting in 4" tube rails from axles to engine frame and mounted loader to that. The rails reduce trans case stress involved with mid-mount loaders.