Gc pictures

   / Gc pictures #11  
I primarily use my GC2400 for mowing and origially ordered turf tires. Since I also ordered a FEL my dealer sent me a unit with R4s. I was skeptical but have not had issues with tearing the turf. They also ride smooth on hard surfaces. The last reason I think I'll keep them is that I'm told the turf will squash more than R4s when lifting heavy loads with FEL. Haven't tested that yet.
 
   / Gc pictures #12  
"I'm told the turf will squash more than R4s when lifting heavy loads with FEL."

Yes, they will. Turf tires, by design, I guess, have "soft" sidewalls, and they WILL squish down with loads. So far, however, mine have held up...:thumbsup:

I still haven't gone too far into the woods yet, but am beginning to get there. That's where my turfs may fail me.... we'll see.
 
   / Gc pictures #13  
"I'm told the turf will squash more than R4s when lifting heavy loads with FEL."

Yes, they will. Turf tires, by design, I guess, have "soft" sidewalls, and they WILL squish down with loads. So far, however, mine have held up...:thumbsup:

I still haven't gone too far into the woods yet, but am beginning to get there. That's where my turfs may fail me.... we'll see.

Miy turfs don't squash at all.
 
   / Gc pictures #15  
Well, my little beastie just pulled out her first stump! Kinda dirty --wet soil-- but it'll clean up OK. Took a while, took some patience... and this stump was pretty small!:eek:

Pics don't show it, but there was a pretty steep slope to go down to get at the stump; not much room to maneuver between the still-standing trees-- but it did it!:thumbsup: (And no flats yet!)
 

Attachments

  • stump rmvl 6:2010-1.JPG
    stump rmvl 6:2010-1.JPG
    155.1 KB · Views: 188
  • stump rmvl 6:2010-2.JPG
    stump rmvl 6:2010-2.JPG
    154.3 KB · Views: 191
  • stump rmvl 6:2010-3.JPG
    stump rmvl 6:2010-3.JPG
    154.4 KB · Views: 170
   / Gc pictures #16  
What size tires are on the front/rear.I noticed it can be had with ag tires but the stock ones look like they wear out fast

I have R4 Industrial Tires front and rear. They are Titan - Trac Loader Tires. Fronts are 18x8.50 - 10 NHS 4 ply, and the rears are 26x12.00 - 12 NHS 4 ply. NHS is not for highway service. Good luck with your search for a tractor :thumbsup:. KC
 

Attachments

  • IMG_1074.jpg
    IMG_1074.jpg
    564.8 KB · Views: 212
  • IMG_0806.jpg
    IMG_0806.jpg
    1,005.7 KB · Views: 220
   / Gc pictures #17  
the ag tires on mine do squash down a bit, but they will handle everything that the fel will pick up.
 

Attachments

  • agload.JPG
    agload.JPG
    160.4 KB · Views: 183
   / Gc pictures #18  
Here's a couple of pics of mine that I took not long after delivery, along with my other "toy". :D

100_3993-717x481.jpg


100_3995-712x478.jpg
 

Tractor & Equipment Auctions

forklift skytrack (A56857)
forklift skytrack...
2018 DODGE RAM 2500 (A58214)
2018 DODGE RAM...
2015 CHEVROLET CRUZE (A56859)
2015 CHEVROLET...
2019 KUBOTA U35-4 EXCAVATOR (A52706)
2019 KUBOTA U35-4...
2007 IC Corporation PB105 School Bus (A54814)
2007 IC...
1999 FREIGHTLINER FLATBED (A58214)
1999 FREIGHTLINER...
 
Top