jlgurr
Veteran Member
- Joined
- Oct 21, 2013
- Messages
- 1,024
- Location
- Bostic, NC
- Tractor
- Massey Ferguson GC1705, John Deere STX46
Believe me, I am looking forward to sharing this new info with the dealer.
Sent from my iPhone using TractorByNet
GC1705 - DL100 - Float Position
- Thread starter ChrisInKY
- Start date
- Views: 19320
Believe me, I am looking forward to sharing this new info with the dealer.
Sent from my iPhone using TractorByNet
MFRED
Platinum Member
You mean it won't break that day?
The levers do have a habit of breaking.
They stupidly made it thinner, right were all the stress is.
I have had to weld mine. :confused3:
If MFRED says it has a float, I am going with him. The dealer must be wrong, and also not able to engage it.
The new joysticks are heavier than what they were using and I can't say I've heard of one breaking. Yet. Downside to that is they're probably just as overpriced as the cheesy bent one on the older models.
You were not pushing hard enough?
Ya - you have to push to levels where you are pretty certain it's going to break, then it clicks into spot with a nice clank. I did it with the tractor off so I wasn't fighting the bucket trying to lift the tractor, haven't put the loader back on to try with the loader yet....
jlgurr
Veteran Member
- Joined
- Oct 21, 2013
- Messages
- 1,024
- Location
- Bostic, NC
- Tractor
- Massey Ferguson GC1705, John Deere STX46
Mine seems to go there easier if I do it quickly, almost like "snapping" it in to float position.
kboggs
New member
- Joined
- Oct 11, 2012
- Messages
- 14
- Location
- Frankford, WV
- Tractor
- John Deere 950, Massey Ferguson GC1705
Well I'll be darned! Just reading threads and seen this one. My 1705 sure does just clank right into float. Can't say I ever used it or even knew it was there. So after reading walked out to the garage and figured it out.
Kevin.
Kevin.
jeepcj7
Platinum Member
- Joined
- Oct 18, 2004
- Messages
- 601
My understanding is the detent was made stiffer on the GC1700 because there were too many complaints of the GC2400/GC2600 popping out of float. I believe they may be looking into a lighter detent spring than the current one being used, but still stiffer than the one used on the GC2400/GC2600.
Kevin Krieger
Member
So for you guys with the backhoes, have you tried the float with the right lever? I tried it with backhoe on stand and didn't seem to work. I need to hook it up and try it. So I just pull towards me on right lever pretty hard?