good home cheap

   / good home cheap #1  

mdbarb

Gold Member
Joined
Oct 27, 2000
Messages
370
Location
Northern California
Tractor
B21
I finished this project last weekend. Its wind, rain, water, fire and earthquake resistant. It worked out to about $7 per square foot.
 

Attachments

  • 438154-DSCN0034100k.jpg
    438154-DSCN0034100k.jpg
    87.1 KB · Views: 593
   / good home cheap
  • Thread Starter
#2  
A progress shot - as usual - the first steps are the most important
 

Attachments

  • 438157-DSCN0027100k.jpg
    438157-DSCN0027100k.jpg
    93.3 KB · Views: 381
   / good home cheap
  • Thread Starter
#3  
All done but the hard part
 

Attachments

  • 438160-DSCN0032100k.jpg
    438160-DSCN0032100k.jpg
    93.8 KB · Views: 346
   / good home cheap
  • Thread Starter
#4  
3/4 done
 

Attachments

  • 438161-DSCN0033100k.jpg
    438161-DSCN0033100k.jpg
    93.1 KB · Views: 340
   / good home cheap #5  
Rebuilding already /forums/images/graemlins/grin.gif? Just kidding. How's everything going these days? G
 
   / good home cheap #6  
And a well proven design too.
Open up the top vent and roll up a side a little and theres an induced cooling draft in hot weather. Fire in the middle in the winter.
On the farm where I gew up there was an area in which you could still find the teepe ring stones and fire circle stones.

Egon
 
   / good home cheap
  • Thread Starter
#8  
Some of the common sense aspect of this design:
The outer cover is about 6 inches above ground, the inner liner goes from the ground to about 6 feet. It is fastened to the inside of the poles. This creates a 6" wall cavity, cool air is sucked in from below and spills out above, this creates a draft so one can have a fire inside and the smoke will draft out the top. Any rain that would come in thru the top runs down the poles in the wall caavity, down to the outside, keeping the inside dry.
 
   / good home cheap
  • Thread Starter
#9  
Actually there are too many wrinkles - I tied the tipi to lift lifting pole about 4 inches too low, so there is some slack in the top half, causing wrinkles - I've been in contact with the mfg and will probably fix it this weekend.
 
   / good home cheap #10  
</font><font color="blue" class="small">( I've been in contact with the mfg and will probably fix it this weekend. )</font>

Who manufactures it? I would like to get more information on building one of those.
 

Tractor & Equipment Auctions

2020 KENWORTH T680 TANDEM AXLE SLEEPER (A54607)
2020 KENWORTH T680...
2021 Interstate Tiltbed 40TDL 24 Ton T/A Flatbed Trailer (A52377)
2021 Interstate...
2006 Toyota Tundra 4X4 Pickup Truck (A53422)
2006 Toyota Tundra...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2015 Peterbilt 320 T/A EZ-Pack Front Loader Garbage Truck (A54814)
2015 Peterbilt 320...
20X30 ALL STEEL CARPORT (A53843)
20X30 ALL STEEL...
 
Top