sodamo
Super Star Member
- Joined
- May 20, 2004
- Messages
- 18,484
- Location
- Big Island, HI
- Tractor
- Bobcat CT4545 LS XR4140H (Mine) BX2380 (wife’s)
Gee BEF, not a good oops.
Gee BEF, not a good oops.
decided I hate the combo convection unit in the rv, went to read the directions, again, and they must have fallen behind drawer, into a void I can't see or get to.
Lovely. 7 things I'm trying to heat up for dinner, not good planning, have them all hot at once, heated sequentially in a device I can't understand. At least the new machine smoke burned off, had the fan on just in case and it was needed.
Sometimes the GDO works, but now it goes about a ft and abruptly stops.
So got out extension ladder and started putting up chain opener hoist for the 10ft door. Hoist hits a 2x6 nailed along the 6x6 pole. Poor design in my opinion. Standard offset for clopay door. I already cut a 1” rod to extend the pipe length, if I had known I could have cut it a half “ longer and made it work. I can cut another rod, or trim the 2x6 10 ft in the air.
Got too tired, had to stop.
Your GDO obviously should not warp like that. Do you have the door's springs adjusted so that it doesn't take much force to lift? I'm back to worrying again.
.