Good Morning!!!! 79F @ 7:00AM. Abundant sunshine. Near record high temperatures. High 111F. Winds light and variable.
The Lucas grease I mentioned is polyurea, another clue that it might be the same as what JD is selling. Not needed for mower spindles, but according to the videos in
this post, it won't hurt them, either. If you had to pick one and only one grease for everything, the polyurea would be a good choice. It has a NLGI GC-LB rating, as explained in
this video. Moly isn't good for roller and ball type bearings, but it's the best high pressure additive you can get for FEL type pins.
One of the best ways to find something you've misplaced is to go buy another one, Drew...
That might be the cutest turkey shot ever, Ron!
Years ago I made up a test light by soldering a pair of wires to an old brake light bulb. Hardly ever used it. Picked up a real test light last year, and hardly ever use that, either. I seem to reach for a DVM anytime I'm doing electrical work, since it does resistance, continuity with a beep, voltage, and current measurements all in one tool. Hope you find the bug in the Yaris without too much trouble, Kyle. You've already got a lot on your plate with all that hail damage.
The water situation in California is yet another man made problem having its roots in mismanagement, Drew. It doesn't take a climate scientist to understand that a growing population (at least until the most recent census) will need more water. And that agricultural needs dwarf those of residential users. If you look at the levels of any of the California reservoirs, they fluctuate all over the place, and have done so since they were built. That's why they were built in the first place: flood control. They also store water for use in the dry summers. But instead of building more reservoirs, older, smaller ones are being dismantled because the agencies and businesses that own them don't want to pay for the cost of maintaining them. And plans for new, large reservoirs seem hopelessly snared in red tape, and have been for years. Same story with the electrical grid, specifically generation capacity. Years ago, PG&E sold off most of its generation capacity to save money on maintenance costs. Now they have to buy power on the open market during periods of high demand, resulting in one of the highest rate schedules in the country. Same story with wildfire. Years of neglecting the fuel loads in our forests causes huge fires that can't be put out except for letting them burn until they exhaust available fuel. But cleaning up the forests costs money, money that is now being used to garner favor with the voters. The voters vote for bread and circuses, and what a circus we have now...
While it was still relatively cool yesterday morning (temps in the low 80F range is considered cool here this time of year, Eric) I measured the lengths of the trench segments. The lateral at the top of the hill is 130' long, the run down the hill is right at 400', and the jog to the pump house adds another 30'. As of yesterday, I only have that last 30' piece to go, but because it runs in the same ground as the electrical, antenna, and phone/ethernet lines, digging will be slow and careful. Yesterday's digging crossed a drain line from the water softener, and because I knew the location where the two crossed, I managed not to break it. I hope my luck continues.
There's another Airheads tech day this weekend, and I'm headed out this morning on the zebra bike to get some time out of the heat and help the organizer get set up tomorrow morning. I'm taking along a drive shaft boot, and depending on how things go, might even install it to replace the torn one on the bike. I've already promised to fix another buddy's over rotating center stand, which should be fairly simple, but who knows what else will show up. Lake Tahoe is a great place to be in a heat wave, though.
TGIF gang!
www.cnn.com
