Homemade Subsoiler Ripper for MiddleBuster
- Thread starter OkieG
- Start date
- Views: 33391
Barnboy
Gold Member
Slots were made with a mill. I didnt use a very heavy piece of steel (1/4") but it worked.
depasseg
Member
You would only need a couple inches of chain. I think you could just weld one link to the rear of the blade. As for attaching the pipe, what kind of pipe is it? Is it poly? If so you could create a loop with the chain and then loop the pipe through the chain and fold it back onto itself, then wrap duct tape around that. This would keep the stress of the pulling on the pipe and not on the tape.Another thing that might help is welding something sorta round to the bottom of the blade, so that as you drag it through the ground, it creates a little tunnel for the pipe to pass through.
Here's a picture that might help. It's from Toro, but the idea is similar. The only thing that would be different would be how to connect the pip to the chain.
Here's a picture that might help. It's from Toro, but the idea is similar. The only thing that would be different would be how to connect the pip to the chain.
Your picture reminds of when the "cable guy" layed cable in our yard. He used a vibrating device with a torpedo shaped piece of steel that led the cable. The cable was held by a loosely woven tube of nylon. I've heard it called a "finger trap" before. As kids we had a similar toy called Chinese handcuffs. A finger easily enters the tube, but won't pull out. I don't know if something like that would work for slippery plastic pipe or not.
OkieG
OkieG
