J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
I have seen wrenches for use with hydraulics, but nothing specifically made for hydraulic lines. In general, wrenches used for hydraulics are thin , with an angle, and some have a swivel end. You can make your own wrenches with a grinder, and a torch. You need two wrenches, one to hold the one side, and one to turn the removable fitting.
Finger tight, plus a quarter turn usually is enough.
Sometimes the only way to get to a hose or fitting is to remove other hoses or fittings.
Finger tight, plus a quarter turn usually is enough.
Sometimes the only way to get to a hose or fitting is to remove other hoses or fittings.