hydro system filter

   / hydro system filter #1  

passgas55

Bronze Member
Joined
Aug 25, 2006
Messages
93
I have a 2210 and was unsure where the filter screen is on it. So I took a pic of where I think it is.

ake64l.jpg


Am I right or going in the wrong direction?
 
   / hydro system filter #2  
Right. Probably will need to pry it off once the bolts are out. Clean both surfaces, reassemble with #2 permatex. Drain transmission first or you will get soaked. Hopefully the picture you posted really needs to be rotated 90* clockwise.
 
   / hydro system filter
  • Thread Starter
#3  
I shot the pic by holding the cam sideways forgetting to rotate it afterwards. Either that or my tractor sleeps on its side:eek:
 
   / hydro system filter #4  
Looks like the right spot to me. I just changed and cleaned my YM226, does seem to do better. It says in the manual to use the tractor and get the hyd oil hot and stop, then the sediment will be suspended (in filter). Before you open the drain plug ***open the dip stick and release pressure in it; if you don't you will get covered in hyd oil, like I did... It should be around 3 to 4 gallons of hyd oil.. When I removed my filter cover it did not have a gasket. I cleaned the surface and installed it back without anything on it. It is not leaking at all.... Have fun working on your TOY!!!
 

Tractor & Equipment Auctions

1996 Monon 45X96 Dry Van Trailer (A50397)
1996 Monon 45X96...
1995 Pro Sports 22ft Center Console Fishing Boat with 25ft T/A Boat Trailer (A48082)
1995 Pro Sports...
2007 TRANSCRAFT 48X102 FLATBED (A50854)
2007 TRANSCRAFT...
2019 Generac MLTS-1 2.4kW Towable LED Light Tower (A49461)
2019 Generac...
2025 K1912 UNUSED Metal Livestock Shed (A50860)
2025 K1912 UNUSED...
UNUSED 3/4 in. Polyester Arborist Outdoor Rope (A50860)
UNUSED 3/4 in...
 
Top