RalphVa
Super Member
- Joined
- Dec 19, 2003
- Messages
- 7,902
- Location
- Charlottesville, VA, USA
- Tractor
- JD 2025R, previously Gravely 5650 & JD 4010 & JD 1025R
I'd rent an electric hammer drill. Then put a stud bolt in the bottom of your fence post into the hole you've made in the rock. This plus cementing around the fence post down to the rock should hold it in place.
I put in one of those safety pool covers about 3 years ago. I used my own hammer drill to drill the 4 corner holes. Took me forever and went through 2 drill bits.
I rented a huge hammer drill and was supplied with a concrete bit for it. I did all the other approximately 30 holes in less than 30 minutes. Using the proper equipment will save you lots of time.
Ralph
I put in one of those safety pool covers about 3 years ago. I used my own hammer drill to drill the 4 corner holes. Took me forever and went through 2 drill bits.
I rented a huge hammer drill and was supplied with a concrete bit for it. I did all the other approximately 30 holes in less than 30 minutes. Using the proper equipment will save you lots of time.
Ralph