JD 2240 and splitter

[magarj]

I am thinking about running a firewood splitter behind my 2240. The 2240 has an AUX output at the rear and I would like to use it to run the splitter. I know the splitter has a standard detent valve that cycles the blade through the wood. Is there anything I need to do special to the AUX output to make the splitter work? There is a lever that controls the AUX output that I use to raise/lower my disk but I am not sure if it does "constant pumping" if I raise it all the way to the top?

Anybody know if it will work?

Thanks in advance!

Jeff M

 

[kennyd]

It should work fine, but you will probably need to bungee the handle for the remote valve AFTER the splitter is hooked up so the flow will be constant.