JD 4600 with 460 loader - loader control lever won't curl or dump

   / JD 4600 with 460 loader - loader control lever won't curl or dump #1  

leadfarmer

Member
Joined
Oct 13, 2019
Messages
34
Tractor
Kubota L3400-MT, CAT 85J 955L, 44A D6B, 1937 R5 Gas Dozer
I have a JD 4600 with the 460 loader that had been sitting outside for several years without use. The loader will lift and lower but when I try to move the loader control lever side to side for the dump and curl it feels like it is locked. It hits solid resistance both ways. The control function lock lever below it is in the unlocked position. I will have to get under it and look at the linkage, but does anyone have experience with this issue?
 
   / JD 4600 with 460 loader - loader control lever won't curl or dump #2  
Almost everyone suggest this. Check your QD's. Plug and unplug them to confirm they are engaged completely.
 
   / JD 4600 with 460 loader - loader control lever won't curl or dump
  • Thread Starter
#3  
It was just stuck linkage. I made sure the valve was able to wiggle then I just muscled the control stick into moving side to side. Liberal application of Kroil and a thousand back-and-forths later it is now moving as it should.
 

Tractor & Equipment Auctions

2021 JOHN DEERE 410E-II 6X6 OFF ROAD DUMP TRUCK (A51242)
2021 JOHN DEERE...
2017 Ford Escape SUV (A50324)
2017 Ford Escape...
YAMAHA ELECTRIC GOLF CART (A51244)
YAMAHA ELECTRIC...
Swict 78" Bucket (A50121)
Swict 78" Bucket...
2009 CATERPILLAR 420E BACKHOE (A51406)
2009 CATERPILLAR...
TEST YOUR BID BUTTON! (A51243)
TEST YOUR BID...
 
Top