I recently purchased a 2002, 2wd, 990 with 774 hours. No maintenance history. I plan to change filters/fluids and alternator belt. Will appreciate any advice. The online manual I'm using doesn't mention the fuel filter under the fuel tank.
JD 990
- Thread starter JLWjr
- Start date
- Views: 2074
-
- Tags
- john deere 990
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,613
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Would suggest getting a copy of the service tech manual.. sounds like a good tractor
TractorTech
Elite Member
- Joined
- Jan 26, 2012
- Messages
- 3,025
- Location
- California
- Tractor
- Ford 7710, Ford 550, Ford 1910, Ford 4430, KD Forklift, Ford LGT17H, New Holland L255 Skidsteer
I would change the fuel fllter. If a cartridge type filter, make sure you get the inner oring and the bowl oring.
joecdeere
Veteran Member
- Joined
- Apr 13, 2002
- Messages
- 1,722
- Location
- Cumming,Georgia
- Tractor
- 1948 Allis UC Hi-Crop Cane 1941 Allis WC 1948 Allis G with loader, 1948 Allis G with dual disc 1948 Allis G 1948 Allis G 1949 Allis G 1954 Allis G 1959 Ferguson TO-35 1972 MF 135 1979 Power King 2418 1989 Ford 345C TLB
The one under the tank is a water trap / separator, go ahead and take it apart and wash it out element should be washable
Many thanks. I'm slowly getting to all the fluid and filter changes.
I have completed the fluids and filters changes. I now have an issue with the transmission oil change. The manual states "approximately 5.5 gallons" to replace the oil. The issue is that the dip stick is indicating a low level. Oil is only covering the tip of the dip stick with nearly 6 gallons poured in. Anyone have a possible explanation?
Thanks
Thanks
RjCorazza
Elite Member
Tractor transmission specifications are notorious for the spec capacity being different from what goes back in. It's usually the other way around though... 5.5g spec, and only 5.0 goes back in. Likely due to the difference between a factory "bone dry" fill, and an incomplete drain.
I would run the machine for a little while and see if it changes. If it still reads low, add whatever is necessary to get the correct dipstick level.
