Jul 31, 2020 / Jinma 254 pto engagement Thread Starter #21 OP W Whenu Member Joined Jul 19, 2020 Messages 34 Location Kaitaia,New Zealand Tractor Jinma 254 Got all the bits out, apart from the 50T gear, wear on the meshing slider not too bad. Is the bearinr in the case supposed to be flush or a bit proud?
Got all the bits out, apart from the 50T gear, wear on the meshing slider not too bad. Is the bearinr in the case supposed to be flush or a bit proud?
Aug 5, 2020 / Jinma 254 pto engagement Thread Starter #22 OP W Whenu Member Joined Jul 19, 2020 Messages 34 Location Kaitaia,New Zealand Tractor Jinma 254 Had a practice run at putting it all together and the sliding sleeve moves right over to the outside of the gear, odd, not sure what I did different to what it was like before, maybe the 50T gear splined shaft was on backward.
Had a practice run at putting it all together and the sliding sleeve moves right over to the outside of the gear, odd, not sure what I did different to what it was like before, maybe the 50T gear splined shaft was on backward.