mblair441
New member
- Joined
- May 30, 2010
- Messages
- 13
- Location
- Ira, Texas
- Tractor
- 1959 JD 730, 2017 JD 1025R, 1956 Ferguson 40, 1959 Farmall Cub, 1982 JD 318, Case 580B, JD 350B
On my JD 318 with a 50 inch deck, there is an arm that holds the tensioner pulley that pivots from where it bolts to the deck. The bolt to the deck has bushing through the arm housing through which the bolt goes. Is the bushing a press fit into the arm, or should it turn inside the arm housing, with the bolt turning inside the bushing? Thanks, Matt