Hello, I have a 3320 Compact Tractor and the rear axle seal is leaking. I ordered the parts and are on the way to me. I am looking for someone who has done this before. If I take the four bolts out at the end, will the axle just come out? Is there a snap ring that hold it in, and I need to take the transmission casing apart? I have been looking for information or videos online, but I can not find anything. Has anyone replaced the seal before? Can anyone help me out. Thanks Scott
John Deere 3320 Rear Axle Seal
- Thread starter GR8TSCT99
- Start date
- Views: 1453
joecdeere
Veteran Member
- Joined
- Apr 13, 2002
- Messages
- 1,690
- Location
- Cumming,Georgia
- Tractor
- 1948 Allis UC Hi-Crop Cane 1941 Allis WC 1948 Allis G with loader, 1948 Allis G with dual disc 1948 Allis G 1948 Allis G 1949 Allis G 1954 Allis G 1959 Ferguson TO-35 1972 MF 135 1979 Power King 2418 1989 Ford 345C TLB
sadly it's just not quite that easy!
I have a PDF of the technical manual you're welcome to, shoot me your email if wanted.
You have a good bit of reading to do before tackling this job
these are just two quick pics from the manual about what all is in the way and the case you must remove to get the axle out -
I have a PDF of the technical manual you're welcome to, shoot me your email if wanted.
You have a good bit of reading to do before tackling this job
these are just two quick pics from the manual about what all is in the way and the case you must remove to get the axle out -
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 10,536
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
It looks like his leak will either be the seal or the o-rings on the inside of the seal bushing. By the looks of the picture, it would be worth the try taking out the 4 bolts, sliding it out of the gear/bearing that are on the deep end. The snap ring should get the parts off the shaft.
I got the gasket for the end cap, the axle seal, and the o rings ordered. It looks like i have my work cut out for me. Thanks for the reply, I will read through the pdf file and see what it says and hopefully it is not as difficult as it sounds. Thanks, I will let you know how it goes
sadly it's just not quite that easy!
I have a PDF of the technical manual you're welcome to, shoot me your email if wanted.
You have a good bit of reading to do before tackling this job
these are just two quick pics from the manual about what all is in the way and the case you must remove to get the axle out -
I would love to see a copy of the pdf file. It looks like i have my work cut out for me. My email is: Saenneking@covenantretirement.org
I sent it in a personal message but don't know if it sent correctly. Thanks for your help, I am looking forward to seeing what I am getting myself into.
Last edited:
