richard zimmermann
New member
blowing #1 fuse
john deere 5425
- Thread starter richard zimmermann
- Start date
- Views: 4588
-
- Tags
- john deere 5425
Can you provide a little more information, here is a link to help you get to the operators manual, so you can tell us what that fuse does.
John Deere Ag - New Equipment: Technical Publications - Publications Search
Does the fuse blow as soon as you turn the key?
If yes, I believe the problem is the thermistor sensor (thermistors are temperature variable resistors used as sensors.). On the thermostat housing there is a sensor that is connected to a two wire harness that goes to the injection pump; this is the "cold start advance" portion of the system so it starts easier when cold by advancing the timing.
When the sensor on the thermostat housing fails it shorts out and blows the fuse. Try unplugging it, replace fuse and see if it starts and runs. The part # is RE503242, if you are quick changing it, you don't have to drain the coolant, just make sure it's not hot at the time. You will want a pan under the tractor to catch the coolant, so as not too have to clean it up.
To comply with the exhaust emissions regulation, the timing of injection pump should be around 6 to 9 degrees before TDC. These timing values do not allow proper start-up operations when engine is cold. To ease engine start-up, a cold advance system gives to the injection pump a temporary over-timing.
John Deere - Parts Catalog
John Deere Ag - New Equipment: Technical Publications - Publications Search
Does the fuse blow as soon as you turn the key?
If yes, I believe the problem is the thermistor sensor (thermistors are temperature variable resistors used as sensors.). On the thermostat housing there is a sensor that is connected to a two wire harness that goes to the injection pump; this is the "cold start advance" portion of the system so it starts easier when cold by advancing the timing.
When the sensor on the thermostat housing fails it shorts out and blows the fuse. Try unplugging it, replace fuse and see if it starts and runs. The part # is RE503242, if you are quick changing it, you don't have to drain the coolant, just make sure it's not hot at the time. You will want a pan under the tractor to catch the coolant, so as not too have to clean it up.
To comply with the exhaust emissions regulation, the timing of injection pump should be around 6 to 9 degrees before TDC. These timing values do not allow proper start-up operations when engine is cold. To ease engine start-up, a cold advance system gives to the injection pump a temporary over-timing.
John Deere - Parts Catalog
Attachments
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
Hi, Richard. Welcome to the forum! I moved your thread to the JD section so you will get more replies. Good luck with your 5425 