john deere 5425

Tractor **** off when running, would not start, no power to ign switch, found f1 fuse blown replaced and popped again immediately while switch was turned on , turned switch off, replaced fuse and blown a second one when turned on, pulled console, and removed switch, replaced f1 fuse, no power to...

When you turn the key all I get is a fast turning sound, loud hum. I replaced the starter motor and solid about a year ago when we had similar symptoms. Could the starter or solid be bad already. We do tend to start and stop it often, Probably more so than the average operation. Craig

Power to starter relay but goes away when you engage starter switch.

Earlier this week my across-the-road neighbor brought his JD 5425 over to move some pallets of bricks and cinder blocks that my tractor could not hope to move. (He had nothing on the rear for ballast and those pallets made even the 5425 visibly light in the rear tires, double wheel weights and...

Tried to start it the other day about 25 degrees outside, but after turning switch on there was no dash lights, no radio, would not turn over, etc. However the 4 way flashers still work and the work lights are working. Battery is good, but the 20 amp (ignition fuse) F1 was blown. So I put...

Anyone have a link to download the JD 5425 Operators Manual? (All I could find on the Deere site were Technical Manuals.). Thanks!

Tractor battery plenty hot but it’s like the battery is dead. Lights are very bright and readily come on. When the ignition key is turned on nothing happens.

Hello, I've been visiting this forums for years, but have only recently registered, so first let me say thanks to all the members who have contributed their knowledge and insights over the years. We have a 2006 John Deere 5425 cab model. Over the years we have used it almost exclusively as a...

I have a John Deere 5425 with cab. I can run the tractor all day under load without the AC on and no overheating issues at all. I can turn that AC on and I can start watching that temp gauge slowly go up until I have to turn it off. The temp will return to normal. I have made sure that the...

Status is when I start tractor..... idle RPM=0. If i rev throttle the RPM starts going up but maxis out at 12-1500 RPM. Other wise runs well and everything is working fine.... Just RPM is not registering correctly. I figured it had t b the tach/RPM sensor. Put a new sensor on ($40) ...

Have a new to me 5425. Its a 2005 model and has spent its entire life pulling around a 15 foot batwing finish mower at a horse farm. The 3 PT is in full up position and I have been unable to get it to go down so far. Have adjusted the drop valve, and have the lift handle full down. Jumping...

Hey guys and gals, I have a question about the John Deere 5425 and 5525. They seem to have the same motor except the 5525 has 10 or so more HP. So the question is how do they get 10 more HP out of the same engine? The reason I ask is, I have a 2008 Cab 5425 and was curious how to get the extra...

I purchased this tractor used with about 525 hours about 1 year ago. I changed all filters and fluids except I did not change the hydraulic fluid (it looked ok). The hydraulic filter was changed. Currently, the brake pedals (with lock engaged) depress and stop ok but do not return upward...

I hooked up my 8' cutter for the first time this year yesterday. Engaged PTO lever and all seemed good at first cutting over some very light stuff that had already been cut a week or 2 ago. Then I hit some thicker uncut area and the PTO RPM slowed significantly almost as if PTO wasn"t engaged...

I have had my JD 5425 for several years. In the beginning (it was a used tractor), all was well. However the 3 point started acting up. Once unwanted behavior started, they continued. Here are some notes but I don't know if they are related. 1) When I use the 'slow' up/down buttons on the...

blowing #1 fuse

My tilt steering wheel wont stay in one place. Is the gas cylinder replaceable? If so where can I find one?

The JD5425 was originally sold from the factory in George, so it does not have a preheat device for cold weather. So I got the air intake heater kit from JD and tried to install it. I got as far as installing the heater unit on the air intake manifold. I was going to wait for another day to...

New member and expect a search of this subject may have some answers but have to post first before I can have access.

We have a JD 5425 and one side of the rear Hydraulics has stopped working. Worked fine last time out yet was unusually hard to disconnect when thru. Next time out, nothing on the left side. Right side works fine, we don't ever use the mid-mount so no idea if it works or not. I assume it does...

While cranking my 5425, I lost all power and traced it to the 20A F1 fuse , which repeatedly blows as soon as I turn the key. Thoughts qnyone? Thx in advance. Tom Shands

Hello. I am new to this forum but have just experienced a new problem to my 5425 that I have owned for several years. When starting today, it turned over several times then everything electrical went dead. The instrument cluster remains blank when the key is turned on. The blinking hazard...

My front wheels will not engage to 4wh drive and I have replace the switch. Can anyone tell me where the silinoid switch is loacated?

As soon as I turn the switch my F1 fuse 20 amp switch blows. I was told that it was my cold start advance switch blowing the fuse. Does anyone have a wire diagrahm or can tell me exactly where this sensor is. Thanks Steve

I went to do some mowing yesterday, but as I tried to rev up to 2400rpm using the hand throttle I discovered that I could only get to about 1800rpm with the hand throttle as far forward as it would go. It still idles correctly, and the foot throttle will rev it up to full speed, but the hand...

I have a problem , when i turn key on to start tractor ,the dash instrument panel lights take afew seconds to come on and then when attempting to complete the starting process by further turning the key ,the starter will fail to engage and all the instrument lights will go out does anybody out...

I have been lurking around here for about a year asking a lot of questions about new tractors while i was shopping for a tractor. As always you have provided me an enormous amount of info and guidance, and i want to thank everyone for their time, patience, and knowledge. We purchased a JD...

Key Cylinder is damaged and want to replace it. How do I access and remove the key Cylinder for a 5425 JD loader?

Wanting to buy a John Deere 5425 4x4 rops, stradel mount with loader, with 1200hrs or less.... What do y'all think and prices? And do y'all know of anybody that's has one for sale?

My JD 5425 4wd, 2005 model, purchased new, has a dry clutch with a cable to the clutch pedal that has been adjusted once at 50 hours by a JD mechanic but even then the cable was too long. The cable needs further adjustment but cannot be made shorter, it is as far as it can go. When I step on the...

my lock on my differential will not engage or disengage when I drive the tractor and let off the gas the brakes seem to drag any ideas please any help would be great!

Deere tells my father "He is the only person that has starting problems with a 5425 tractor". We are looking for any service updates issued by Deere or any information on a 5425 tractor with starting problems. If Deere has any service updates out there that would be useful, or if you have this...

Have trouble starting my 5425. Dealer says to bleed lines of air. I do it according to the instructions, but usually only is ok for a couple days, then have to do it again....any help appreciated. I gave up on my Dealer.

Anybody have problems with 24x24 transmission hi/lo shifter. My friends 5425 24x24 has given problems not shifting hi to lo speed he has about 425 hours. I am approaching 350.Should I be concerned?

Just wondering if anyone has experienced problems starting their 5325, 5425 or 5525 Deere and keeping it running. Have a tractor that will crank and start, runs for 3 seconds, RPM's fall off/surge, dies, and won't restart. This is after it has been setting for a few days. Fuel system must be...

Have had problems with Deere 5425 not wanting to start after setting for a few days. The tractor will crank and start, the RPM's begin to drop off/surge, tractor dies, and then will not restart. Lines must be bled. Please elaborate if you have encountered a similar situation with a 5325, 5425...

Just wandering if anyone has had problems getting their 5325, 5425 or 5525 Deere to start and stay running? Own a Deere 5425 and it will not run after setting for a few days. Have installed check valve in fuel system. The tractor will crank once and start, RPM's fall off/chokes down, and then...

Since I intend to buy used, the main difference I see is the 5425 has the same engine but Turbo charged with the same HP. Is this an advantage? or a mute point? Any difference in torque? I am thinking a turbo is one more thing to go wrong, but maybe more fuel efficent? The 5425 has an electric...

My first post ! I have a 2007 model, John Deere 5425 [Turbo] w/ 542 Loader. Here are the tractor specs : Product Specification for 5425 Utility Tractor (81 hp) Loader specs : John Deere Ag - New Equipment Features for 542 Loader I need to find a brush/tree "hog, mulcher, etc."...

I am looking at getting a JD 5425 with all the bells and whistles, loader 3rd valve on the loader air ride suspension, rear link arm leveler on the fender, buddy seat, 24x24 power reverser, dealer quoted 48,700 cash price, but i know i am going to need to borrow around 10,000. does this sound...

I am currently looking at a new JD 5425 with a cab and self level loader with many options. Can someone help me with comparable models in Kubota, NH, Massey. I have been quoted $47,200 for the JD. Your thoughts. I am located in New Hampshire. Thanks for your insight.

My JD 5425 currently has R1's (16.9X30 rear and 11.2X24 front) with the rears loaded. By the time I have that weight, the tractor weight, the cab weight, the FEL weight, the nearly 600 pound weight of the JD 84" Worksite Pro bucket and the JD MX8 rotary cutter on the tractor, I'm coming in a...

After having just spent the last 3 1/2 weeks comparing the Kubota M7040 to the John Deere 5425 and to the New Holland TN75DA, and after reading many of the excellent posts here on TractorByNet, I have placed an order for the Kubota M7040 :). By my best estimation these are all exceptional...

I just got a price quote on a new 5425 as follows: 35400 2WD air sean vertical exhaust dual remotes dual mid telescoping hitch quick hitch 4200 jd loader with bucket total 39600 It appears to be about 17% off list. This is probably a step up for me as I was originally looking at Kubotas at...