Kioti NX5510 Randomly won’t start

[JC2398]

Good evening all-

My NX5510 developed some kind of problem today and now it won’t start. I’m hoping someone may have some good advice.

Background notes:
-I was running it for a couple hours of normal bush hogging and it was running fine. I parked it and cut it off for about an hour and after that it wouldn’t start.

-It’s a shuttle shift and when I turn the switch on, the shuttle shift lever shows it’s in neutral, no matter what position it’s in.

-Thought it might be the seat safety sensor. It seems to be pressure operated, so I took it off from under the seat and tried manually holding the switch mechanism down…No change in starting.

-It showed “Error code 007” & Error Code 008 sometimes.

-I drained the fuel filter in case it might be water in the fuel.

-I disconnected the battery and reconnected it to try to clear the error code.

I’m at a loss for what to do next. Thanks for any help.

 

[ptsg]

A bit more info on the 007 and 008 codes. Essentially, it's some safety switch not working right.

Understanding Error 008

I purchased a new NX4510 over the weekend and had a backhoe put on Monday so today was the first day I have operated the tractor. It was delivered and I got home and unfortunately it would not start and had the error code 008. Dealer said it's nothing to worry and said it won't start cause I'm...

www.tractorbynet.com

 

[JC2398]

A bit more info on the 007 and 008 codes. Essentially, it's some safety switch not working right.

Understanding Error 008

I purchased a new NX4510 over the weekend and had a backhoe put on Monday so today was the first day I have operated the tractor. It was delivered and I got home and unfortunately it would not start and had the error code 008. Dealer said it's nothing to worry and said it won't start cause I'm...

www.tractorbynet.com

Thanks for the link. I saw that thread yesterday and was hoping someone might have some updated info.

 

[SlackerHQ]

I have a similar issue with my NX6010, hydro. It will randomly show in neutral no matter where the selector is located. When in this state, the engine will not turn over. It is failing the safety check. It is blowing one of the 10 amp fuses located in the main panel. I bought a big bag of fuses and keep them in the cab, so I don't get stranded out in the field. It has been to the shop twice for it, they replaced the main safety controller twice under warranty and it is still happening. Good Luck