I have a Koyker 140 FEL that I am trying to replace a piston in one of the hydraulic cylinders. I was only able to remove the old piston by unscrewing it over the threaded portion using a pipe wrench. When I tried to install the new piston I ran into same problem. The only way to get it started on is to screw its onto the threads on the end. The shaft cuts threads into the aluminum piston but was not able to get it all the way on. I ended up ruining the new piston also. Any idea how to get the piston over the end of the shaft? Will cooling the shaft cause it to contract enough to make the piston fit?
Koyker cylinder piston replacement problem
- Thread starter rstuart
- Start date
- Views: 1122
Roadworthy
Elite Member
Really and truly, if the job was mine to do I'd just take it to the local hydraulic shop.
Leejohn
Elite Member
Does that piston have a blind hole in the side of it??
LD1
Epic Contributor
Pictures would help.
Tx Jim
New Member
Ditto photos are worth many words
BravoXray
Elite Member
- Joined
- Dec 17, 2019
- Messages
- 3,322
- Location
- Nothern Indiana
- Tractor
- Kubota BX2230, John Deere 430 Diesel
Drill a couple of holes in one of the faces and use a spanner wrench to install it.