OP
Anonymous Poster
Epic Contributor
- Joined
- Sep 27, 2005
- Messages
- 29,678
Shane, Before you jump in and start changing the o-rings. Get under the tractor and clean up the area around the block real good. You should see a steel tube, about 3/8"x4" going from the block to the trans housing. If it's bent, that's probably your leak. You'll have to pull the lines and hoses loose and remove the bolts from the block. Pull the block away from the trans and you'll see the o-rings on each side of the tube. WAIT!!!!!!!! sorry, drain the trans first.