I have a L4310 4wd HST Rops with around 2050 hours on it. In the last few weeks I noticed a small drip puddle on the floor under the right floorboard area. After some investigation the leak is coming from the hard tubing/piping interface with the hydraulic block. See picture #1, leak coming from red circle. After some reading it appears both ends of this hard tubing are sealed with o-rings since it is a low pressure line. Picture #2.
When looking at the parts diagram for the L4310 4wd HST Rops, it indicates I should have threaded fittings on this block? See picture #3. Joint #210 and tube with fittings #190.
Am I missing something?
Another question is if I do determine which correct o-rings I need for this hard tubing, do I need to drain 10+ gallons of hydraulic fluid to repair this?
Thanks for any input!
When looking at the parts diagram for the L4310 4wd HST Rops, it indicates I should have threaded fittings on this block? See picture #3. Joint #210 and tube with fittings #190.
Am I missing something?
Another question is if I do determine which correct o-rings I need for this hard tubing, do I need to drain 10+ gallons of hydraulic fluid to repair this?
Thanks for any input!