Looking for a toothbar. need some help please!!!

   / Looking for a toothbar. need some help please!!! #21  
SevenCorners I have the same teeth on my toothbar! I used a 3/8 high speed steel drill running at low speed in a drill press. The teeth are cast steel and they drill pretty easy, I didn't even us a pilot hole. Use a little cutting oil and hammer in some roll pins.

Here is mine with one tooth on and all the holes drilled
 

Attachments

  • 563953-tbar004.jpg
    563953-tbar004.jpg
    58.4 KB · Views: 295
   / Looking for a toothbar. need some help please!!! #22  
If you have crimp on shanks, why not just crimp the teeth on???

Put the tooth on the shank, put the torch to the side of the tooth till it starts to get red and beat it in with a ball peen hammer on both sides. Why drill when it isnt made for it?
 
   / Looking for a toothbar. need some help please!!! #23  
I called Fabco and spoke to Kami but she said they no longer sell to the public, that I would have to go through a dealer to get the teeth.
 

Tractor & Equipment Auctions

2015 Ford Explorer AWD SUV (A48082)
2015 Ford Explorer...
2018 Ford F-450 Crew Cab Knapheide Service Truck (A49461)
2018 Ford F-450...
2007 Amkus Rescue System (A50322)
2007 Amkus Rescue...
2008 INTERNATIONAL 4300 M7 SBA 4X2 DUMP TRUCK (A51406)
2008 INTERNATIONAL...
2020 Kinze 3505 High Speed 6/11 Planter (A51039)
2020 Kinze 3505...
2001 INTERNATIONAL 2574 6X4 (A51406)
2001 INTERNATIONAL...
 
Top