Rotary Cutter loose stump jumper
- Thread starter bdmcgrane
- Start date
- Views: 23315
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,917
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
When I work on a BH, I use my FEL to set it up on its side, then it is no problem to lift the stump jumper up and place it on the splines even with all the blades on it. Just be careful with the blades and pinch points as they will rotate to bottom dead center. A heavy 3/4" drive impact should tighten that nut easily, otherwise you would need to wedge the PTO shaft so it wont turn and use a good cheater bar on a breaker bar to tighten to the closest hole in the castellated nut so the cotter pin will go in.
OH, don't forget to remove the PTO wedge prior to using the mower. BTDT and it isn't pretty when the mower engages.
OH, don't forget to remove the PTO wedge prior to using the mower. BTDT and it isn't pretty when the mower engages.
franklinute
Silver Member
- Joined
- Oct 16, 2008
- Messages
- 184
I also use a loader to put the mower on its side. I also lay down an old tire to catch the upper brackets on the mower as it lays over. Remeber to put some antisieze on the splines. I also scratch a line on the end of the shaft showing where the hole is for the cotter pin.