Manual Hydraulic jacks to powered.

[4570Man]

You can use a single way cylinder on a tractor. They were used for many years on loaders. All you have to do is look up to one quick disconnect

I was referring to the post of making a top link and I stick to my original statement that it won’t work. I should have quoted but I didn’t see the post in between or we posted at the same time.

 

[Dave M7040]

I think most jacks, like hydraulic presses, with their own hand pump are operating at much higher pressures than any tractor's hydraulic system. Around 10,000 psi

Check that fact before doing a lot of work and then finding you have a limp link.

Dave M7040