Massey 135 no start

[forty9ford]

i changed O ring seals on banjo fittings as they were weeping. had to loosen the injector pump to get at rear port. re tighted and bled system, but cannot get even a bit of a weep at injection ports. lots of fuel at supply and return lines, and both low and high bleed ports on pump body. Turns over good but not fire at all.\
Any help would be appreciated.

 

[flusher]

Could be a timing problem if you moved the injector pump.

 

[big bubba]

i changed O ring seals on banjo fittings as they were weeping. had to loosen the injector pump to get at rear port. re tighted and bled system, but cannot get even a bit of a weep at injection ports. lots of fuel at supply and return lines, and both low and high bleed ports on pump body. Turns over good but not fire at all.\
Any help would be appreciated.

did you loosen the injector connections @ each cyl then turn over engine to prime the lines? is this a 3 cyl perkins? sounds like you have fuel to the pump, but maybe air pockets from there to cyl...good luck

 

[brin]

I agree with the air pockets as big bubba mentioned...