Medium Duty Truck

   / Medium Duty Truck #31  
A Ford L8000 is not a medium duty truck.
I wonder how some of the older GMC/Chevy Low-Pros would serve you.

33,001 pounds and higher is the technical cutoff for medium duty and they become heavy duty/class8 then. The Ford 8000 single axels are right along that line but as far as I’m concerned all single axels are medium duty.
 
   / Medium Duty Truck #32  
Hardly any of the single axels have lockers on the rear. It would definitely be a benefit if it did. I disagree with the higher gears especially with a limited motor. My Topkick is wound out to cruise 60 but it would be junk if it was lacking the low end grunt. Also keep in mind a 4.88 gear ratio is pretty high combined with the big tires. A lot higher than a pickup would be with the same gear. A trans with more gears would be a lot better.

Depends on engine torque and transmission. A low hole 1st gear and/or 800ftlbs will overcome numerically low gears.
I had 5.38 in my 4800. It would walk out of anything in 1st (7 speed), but when I was running loads up/down the bypass topped out at 60, I wished I had 4.88. My tri axle had even lower gears numerically, but with an N-14, it would do anything loaded and off road.
Sounds like the OP is hauling show equipment to equipment shows & dealers which would probably mean highway travel. He will not need low grunt for lighter trailers on non-vocational work.

I see lots of single axles with limited slips. Not a true “locker”, but certainly better than an open rear.
My single axle is tagged at 35,000lbs. That puts me in class 8 territory along with all the taxes, fees and BS.
I do agree a lot of single axles are in the 26-33k range which is the upper end of MD.
 
   / Medium Duty Truck #33  
Depends on engine torque and transmission. A low hole 1st gear and 300HP will overcome numerically low gears.

Having a 300 horse diesel in a medium duty is exceedingly rare. Having a transmission with enough gears is also rare. But if you had a trans with enough gears that were properly matched the rear end gears wouldn’t matter.
 
   / Medium Duty Truck #34  
Having a 300 horse diesel in a medium duty is exceedingly rare. Having a transmission with enough gears is also rare. But if you had a trans with enough gears that were properly matched the rear end gears wouldn’t matter.

Depends on how good you are with a fuel screw and a few other things.:laughing:
I did want to mention I meant 800 ft lbs instead of 300HP, so I changed it.
Point is, torque and lo hole transmission can make up for highway gears, especially for the OPs truck duties.
A tri can pull out of a quarry with 20 ton and highway gears because it has a lo 1st gear and 1200 ft lbs. A much lighter single axle with 800tq or a guy with a screwdriver and a little knowledge can make a mechanical diesel pump considerably more powerful.
He doesn’t need to worry about it because he’s not vocational. Go 250+ and no higher than 5.13s and you’ll have a nice highway puller. He won’t like a 210 HP, 6.14 donkey dump chassis for what he’s doing.
 
   / Medium Duty Truck
  • Thread Starter
#35  
I figure a 14k trailer would be easy for a MD truck.
I have a hard time finding the EW of trucks. I assume most of these weigh around 10k?
 
   / Medium Duty Truck #36  
I figure a 14k trailer would be easy for a MD truck.
I have a hard time finding the EW of trucks. I assume most of these weigh around 10k?

My gas Topkick weighs 12k. If you don’t have a dump bed you might get the weight down to 10 but I doubt it. A medium duty wasn’t built for speed but they’ll handle 15k of trailer like it wasn’t even there.
 
   / Medium Duty Truck #37  
004.JPG i like my medium duty 2004 ford f 650 has 24,000 miles on it 300 hp 800foot pounds torque cat / allison air ride air brakes . insured by state farm as personal truck - cheaper than my 2011 chevy / duramax 3/4 ton and i store it 6 months a year so its cheap to own and yes i do tow tractors behind it.
 
   / Medium Duty Truck #38  
View attachment 640024 i like my medium duty 2004 ford f 650 has 24,000 miles on it 300 hp 800foot pounds torque cat / allison air ride air brakes . insured by state farm as personal truck - cheaper than my 2011 chevy / duramax 3/4 ton and i store it 6 months a year so its cheap to own and yes i do tow tractors behind it.

300/800 is a pleasure to drive. Not a lot of downshifting pulling uphill and not a lot of sweating going down the other side. Air brakes are worth their weight in gold. I remember times when I was a little overloaded and air brakes will really stop you
 
   / Medium Duty Truck #39  
Nice truck waycoolmarine. Got the right motor too.
 
   / Medium Duty Truck #40  
I like an 8.3L Cummins in the bigger class 7 and smaller class 8 trucks. They really snort.
You get more displacement than the 7.2L CAT and the DT466.
The 8.3L Cummins is a very proven Agricultural diesel in Case IH magnum tractors.

All of them are good, just my preference.
 

Tractor & Equipment Auctions

2011 Mitsubishi Outlander AWD SUV (A51694)
2011 Mitsubishi...
24in Tractor Backhoe Bucket BT4555 (A53472)
24in Tractor...
LANESHARK LS2 LOT NUMBER 159 (A53084)
LANESHARK LS2 LOT...
2000 Thomas Built Saf-T-Liner MVP-ER Transit Passenger Bus (A51692)
2000 Thomas Built...
New/Unused 2025 CFG MX20R Mini Excavator (A51573)
New/Unused 2025...
2017 Makita HM1307CB 35lb Demolition Hammer (A52377)
2017 Makita...
 
Top