Meyer Plow for my tractor
- Thread starter Diamondpilot
- Start date
- Views: 37996
kennyd
Advertiser
Where are you at Weedbo? Maybe someone close can help out...
CURIOUSGEORGE
New member
My setup is similar, Meyer 6' for $75 (roadside bargain)
about another $75 for new face & misc. steel & bits
A reworked Free-bee double acting cylinder to turn it with some rigging.
Mine had a pretty good cutting edge, but a old timer showed me his setup with a heavy Tube (2") welded on the bottom to keep from scarfing the concrete, float above the gravel/stones, & keep from pealing the turf out. Bonus is you can lose gauge shoes & trip springs to shed some pounds.
seems to work very good & the tube is on it's third year w/out much wear.
about another $75 for new face & misc. steel & bits
A reworked Free-bee double acting cylinder to turn it with some rigging.
Mine had a pretty good cutting edge, but a old timer showed me his setup with a heavy Tube (2") welded on the bottom to keep from scarfing the concrete, float above the gravel/stones, & keep from pealing the turf out. Bonus is you can lose gauge shoes & trip springs to shed some pounds.
seems to work very good & the tube is on it's third year w/out much wear.
Attachments
OP
Diamondpilot
Super Star Member
- Joined
- Jan 18, 2007
- Messages
- 16,331
- Location
- Daleville, IN
- Tractor
- Jinma 254/284 Ford 861 Powermaster at work
Sorry for the late response but any fabricator can weld it up for you. Just make a templet or a careful drawing with detailed measurements. If I made you one it would cost twice as much as the materials to ship it.
Chris
Chris