I was using the front end loader to move debris with the three point raised on my MF 1240. After completing the task, I parked then lowered the three point and front end bucket. Next day, three point would not raise. Front end loader works fine. Hydraulic fluid checked good. I can see the lift linkage rotating into the transmission, so actuation appears normal. I have the service manual and will check the hydraulic pump next - it is unclear if the front end loader and three point share the same pump. Does anyone have any troubleshooting tips or advice?
MF 1240 three point wont lift
- Thread starter RayMF1240
- Start date
- Views: 962
