MF 200 Industrial Shuttle Shift problems

   / MF 200 Industrial Shuttle Shift problems #1  

dmhebel

New member
Joined
Jul 9, 2018
Messages
3
Tractor
Massey Ferguson 200
Hi,

I have a MF 200 that we have had since new. Its equipped with the forward / reverse shuttle shift pedals, and a high / low two speed transmission. Recently decided to change the very brown transmission fluid. Drained from both plugs, ran a little bit to clear the pump. Added Tractor Supply fluid that said it was compatible with the spec fluid number (Don't have this number with me right now). When I first changed the fluid, the tractor would only move in reverse. After sitting over night, it would move forward / backwards fine. Took it for a test mow, and ran fine for about 30 minutes. Then it would start to slow down and then seem to 'catch' and then move again. Eventually it stopped all together, and had to let it sit overnight. Next day it was fine, although it did slow down a few times back to the shop. Its almost like air is getting in the pump, or its cavitating or something. Any ideas? Bad tranny oil?

Thanks ---
 
   / MF 200 Industrial Shuttle Shift problems
  • Thread Starter
#2  
This should have said MF 2200 industrial, it has a 200 loader. Thanks,
 
   / MF 200 Industrial Shuttle Shift problems #3  
Sounds like there is not enough oil in it. Have you checked the oil level in the correct manner?
 

Tractor & Equipment Auctions

2023 54' Hooklift Dumpster 20 Cubic Yard (A53422)
2023 54' Hooklift...
2016 Toro Groundsmaster 7200 Zero Turn Mower (A55851)
2016 Toro...
2015 Kubota KX91-3S2 Mini Excavator (A55973)
2015 Kubota...
MISC LOT (A55745)
MISC LOT (A55745)
2015 Ford Transit 150 Cargo Van (A53422)
2015 Ford Transit...
2011 FONTAINE 48 FOOT STEPDECK (A53843)
2011 FONTAINE 48...
 
Top