Mitsubishi 1650 4x4 with front loader & 3 pt wont work

[pacer1980]

As title sez, I have a Mitsu 1650 with FEL that performs perfectly, but the 3 point wont work.

The control under seat does nothing - I'm thinking thats supposed to control the 3 pt??

But from what I can determine all the hydraulics are only connected to the FEL - would think there should be a valve to switch from one to other??? On the pump bottom is a small steel line portion conx to hose going to side of tranny - pressure route??. Large pipe coming out of top of pump going to bottom of tranny - return route??

I've had the little guy about 3-4 yrs and have never really needed the 3 pt, but right now I DO need it. I got a box blade with it and PO hooked it up and when I got home unhooked it. Way some time later I needed the 3 pt but couldnt figure out how to do it.

So, should'nt there be a valve to switch between the 2??

 

[CausticUrbanCoast]

Can you show the second image without your left comment?

It looks a lot like they bypassed the hydraulic adapter port and disabled the three point.

On yours I am fairly positive it is on the front flat part under your comment bubble.

 

[pacer1980]

This is just from the other side, will it do to help explain

 

[CausticUrbanCoast]

This is just from the other side, will it do to help explain

View attachment 702997

Yup that is what I expected!

That hump is where your hydraulic adapter is supposed to go for the FEL and when you re-route to support your 3-point and FEL

 

[pacer1980]

Is this adapter available do you know? From Messik or ???

 

[CausticUrbanCoast]

This is the basic configuration (it's out of the MT160-MT180 manual and the port is on the side and not the front, but the premises are the same).

 

[pacer1980]

So I would have to have this adapter? Just check the mitsu suppliers and see if there's any available...

 

[pacer1980]

Or could I just add a diverter valve....