My custom pallet forks

[Matt4200]

Here are the pictures I've been waiting for a digital camera to post for over a year. Well, we finally got one.

Pallet forks are great. I think I use them as much if not more than the bucket. The forks are from a scrapped forklift which I obtained for $50 after some dickering. The rack I designed a built myself. They do adjust side to side and have locking notches as they did on the forklift. I still haven't gotten around to painting the rack yet, but someday it will of course be JD green.

 

[Anonymous Poster]

those forks look great!

but reply to your own message and check the "I want to preview my post and/or attach a file" box and then continue and upload a picture and keep doing this to post pictures instead of starting new threads.
Again nice tractor and great looking machine!

 

[MikePA]

Top mount of loader quick attach

 

[MikePA]

Bottom mount of loader quick attach

 

[MikePA]

Here it is on the 3ph. It will fit any Cat. 1 3ph.

 

[MikePA]

Top link on 3ph

 

[MikePA]

lower mounting point on 3ph

 

[Bird]

That's a really nice setup where it can be used on either front or rear of the tractor.

 

[gerard]

great job Mike - you paint those green and you can sell them back to a dealer!!! (I gotta get me some bigger drill bits - don't have anything big enough to drill the holes for the three point hitch lower bolts.). Great set up and looks like it was a fun welding project.

 

[MikePA]

gerard, just to be clear, the forks are Matt4200s, I simply combined 6 separate posts, each with a single picture, into a single post.