My M7060 purchase and usage thread
- Thread starter lpigott
- Start date
- Views: 65848
OP
lpigott
Gold Member
wmonroe
Elite Member
Cool picture. What is that tire off of?
OP
lpigott
Gold Member
OP
lpigott
Gold Member
Posting this because people are asking me about my radial tires. Here are pictures of the front and rear so you can see the sizes. The tires were ordered with the tractor and were put on at the plant in Georgia. They even had Kubota stickers on them.
Attachments
OP
lpigott
Gold Member
Well I am stuck overseas at work for another 2 weeks. Since the dealer didn't pick up my tractor to install the 3rd function kit yet, I called them and had them go ahead and order the creeper gear to install at the same time they do the 3rd function next week. In using the Lane shark cutter I found myself using the clutch a lot, especially when there was really heavy brush at varying heights. If the overhanging limbs were mostly at one height and not thick I could get everything cut driving along in 1st gear but the slower creep gears should be the cats meow for dealing with heavy brush at various heights without having to clutch so much.
KenBike
Bronze Member
You will love the creep in 3rd gear creep at 2000 rpm it is 1.5 mph.
OP
lpigott
Gold Member
Must be different on the 40s vs the 60s? My manual says @ 1960 RPM C1=.27mph, C2=.38mph, C3=.49mph, C4=.63mph, C5=.80mph, C6=1.06mph and L1=1.6mph.
KenBike
Bronze Member
How smooth does your trans shift in and out of Park. My new 7060 is a bit sticky shifting in and out of park. I have to depress the brake and shift with some force.
How is yours?
How is yours?