two_bit_score
Super Star Member
- Joined
- Dec 22, 2008
- Messages
- 12,411
- Tractor
- John Deere 110 TLB, Diamond C 19LPX GN trailer
But these meet the renewable specs.
My Place: a CAT, Mahindra, and Ducks
- Thread starter bindian
- Start date
- Views: 139079
OP
bindian
Super Member
You can take that and the Boy Scout that let you in the door and go soapbox race yourself.
I want American steel.hugs, Brandi
two_bit_score
Super Star Member
- Joined
- Dec 22, 2008
- Messages
- 12,411
- Tractor
- John Deere 110 TLB, Diamond C 19LPX GN trailer
Sorry, American steel is in short supply.You can take that and the Boy Scout that let you in the door and go soapbox race yourself.
hugs, Brandi
OP
bindian
Super Member
...........and make it a year model with no computer chips.
hugs, Brandi
Kyle_in_Tex
Super Star Member
Or DEF....
OP
bindian
Super Member
My 2003 Cummins doesn't use DEF, but has chips. Even an electronic throttle. Nothing I own uses DEF. I hope to keep it that way.
hugs, Brandi
OP
bindian
Super Member
The front bumper spray tank on the lawnmower works way better than expected. I can spray and move along the fence lines, justing my left elbow to steer with the wand in that hand. Or drive slowing and steer with one hand.
At first, I only put in 12 gallons of water & Eraser A/P. Every once in a while the rear tires would spin. I was extra careful along the gully. Last trip of the day, I put in 16 gallons and all worked fine. Now, after all that fab. and install with 3 hours of spraying.............the tank will sit until next year.
hugs, Brandi
At first, I only put in 12 gallons of water & Eraser A/P. Every once in a while the rear tires would spin. I was extra careful along the gully. Last trip of the day, I put in 16 gallons and all worked fine. Now, after all that fab. and install with 3 hours of spraying.............the tank will sit until next year.
hugs, Brandi
OP
bindian
Super Member
Got the CAT grader blade reinforced. 3x3x3/8th inch angle 8 foot long. I drilled #40 pilot holes and took it to my welding shop, were they punched the holes out for 5/8th inch plow bolts.
hugs, Brandi
hugs, Brandi
OP
bindian
Super Member
Made a transport cradle for the grader blade today. Now I can leave it outside. After a year or two, change out the bottom pallet.
With it positioned this way, I just curl the bucket level to the ground and crab in. If needed, I can slide
the blade a little, by hand, to get it in place, then chain it.
hugs, Brandi
With it positioned this way, I just curl the bucket level to the ground and crab in. If needed, I can slide
the blade a little, by hand, to get it in place, then chain it.
hugs, Brandi
OP
bindian
Super Member
Hello, anyone out there?
hugs, Brandi
hugs, Brandi
