Need a little help with my 10LA FEL

[marc2000gt]

I need aid in taking it off and putting it back on. How is it supposed to be positioned and such? I popped the hoses off but did not end up getting the loader off. Then when I put the hoses back on, I had a heck of a time getting the two middle hoses back on. They had pressure on them. I do not have a book on the loader, just the tractor.

 

[engineer bill]

the key to getting it connected on a reinstall is to keep it in a completely relaxed position when taking it off, it seems the more care used when taking it off and disconnecting the easier it goes back on.

 

[daTeacha]

With my 114, you need to keep the hoses on until the mechanical parts are off the tractor, then power down and disconnect. You use the hydraulics to position the bucket and arms correctly with respect to the "foot" and to lift the loader from the frame on the tractor. Then move the tractor slightly, shut if off, move the lever through it's cycles to relieve pressure, and finally disconnect the hoses after which you restart the tractor and slowly back out from under the loader.

 

[marc2000gt]

Thanks for the help. I figured it must not have been in the right position. So when I do get it off does it sit upright so the tractor can go right back into it? Or does it have to be supported?