Need a waterproof clock for dash on open station

   / Need a waterproof clock for dash on open station #1  

JCoastie

Platinum Member
Joined
Aug 29, 2020
Messages
830
Location
Coastal AL
Tractor
LS MT240HE
I'm looking for a clock for the dash on my open station tractor.
I checked out amazon, and other than the little quarter size stick on clocks I'm not finding much. I'd go with those if they were a little bigger so I could read them.
Ideally it strikes a balance of thin enough not to look ridiculous but large enough to see at a glance.
Anyone have a good solution they've actually used?
 
   / Need a waterproof clock for dash on open station #4  
I have an old Casio wrist watch that i took the bands off and just tywrapped it to the side fender handle.
 
   / Need a waterproof clock for dash on open station #5  
I have a wrist watch with a velcro strap wrapped around the handhold of the Kubota. Had it the same place on the JDs.
 
   / Need a waterproof clock for dash on open station
  • Thread Starter
#6  
I might have a wrist watch from a couple decades ago in a drawer somewhere, might give that a try.
 
   / Need a waterproof clock for dash on open station #7  
Try “marine clock” 52mm. That should get you marine rated 2-1/16-inch clocks, on just about any of the online vendor sites, or search engines.

if I was looking for anything to mount on my open cab, I’d put marine in the search, or IP66. Marine results in IPX5 or better water-resistance.

IP is Intrusion Prevention, the first number is resistance to solids, and the second number is water resistance. #5 survives a 1/4-inch jet of water from any direction with out damage. #6 a half inch jet of water.

An IP66 rating means is dustproof, and survives the 1/2 inch terms of water from any direction.

This page gives a good breakdown of what the different ratings mean: https://www.dsmt.com/resources/ip-rating-chart/.
 
   / Need a waterproof clock for dash on open station #9  
I just check my wrist watch. However - if I wanted one - Jigs_n_fixtures makes an excellent recommendation. Go with a "marine clock".
 
   / Need a waterproof clock for dash on open station #10  
Ive used autometer gauges drill hole sits in flush and nice OR use one of their gauge pods. Summit racing or jegs has a nice assortment
 

Tractor & Equipment Auctions

2020 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER (A45678)
2020 FREIGHTLINER...
2018 Freightliner Sprinter 2500 Cargo Van (A46683)
2018 Freightliner...
2016 Nissan NV200 Cargo Van (A46683)
2016 Nissan NV200...
2019 Dodge Journey SUV (A46684)
2019 Dodge Journey...
Heavy Duty Skid Steer Auger SSECAG-Y W/ 6", 12", and 14" Bits (A43476)
Heavy Duty Skid...
Wolverine BC-13-72W, 72" Skid Steer Brush Cutter (A47371)
Wolverine...
 
Top