Need Advice LA723

[Jason H.]

I have a 3130 DT with a LA723. I have a requirement to lift pallets of bagged powder at 2,000 lbs per pallet. I only need to be able to lift them about 2-3 feet high on to a bobcat trailer.
I need a performance curve based on distance from the pin and lifting height. So...my question
If the LA723 is rated at 1600 lbs lifting and I would guess thats all the way up. Can I lift 2,000 a couple feet?? I know I'll need my bushhog on the rear to keep her planted.

Thanks in advance.

 

[Hooked_on_HP]

It thakes the same amount of force whether your lifting it 2ft or 10ft. Plus a pallet will be farther out than your bucket would be so it would be harder to lift than the same amount of weight in the bucket.

 

[Airmale]

It won't lift it. I've tried myself.

 

[JoeL4330]

What about forks for your 3ph?

 

[kbiddle]

I second the motion on it will not lift I too have tried it... It may get them up a few inches... but the "EXPERIMENT" I went through is that the back tire will come up off the ground....

 

[ABE56]

I have a 3130 DT with a LA723. I have a requirement to lift pallets of bagged powder at 2,000 lbs per pallet. I only need to be able to lift them about 2-3 feet high on to a bobcat trailer.
I need a performance curve based on distance from the pin and lifting height. So...my question
If the LA723 is rated at 1600 lbs lifting and I would guess thats all the way up. Can I lift 2,000 a couple feet?? I know I'll need my bushhog on the rear to keep her planted.

Thanks in advance.

Jason , I have a L3400, w/ FEL and woods 80 backhoe. This weekend I was moving boulders and had a heck of a time w/ one large one. I could only get it 4" off the ground. Out of curiosity what was your RPM's that you were running. I found my bucket couldn't lift it but the tractor was able to move it
thanks