Need some 4110 assistance...

   / Need some 4110 assistance... #1  

Keith_B

Platinum Member
Joined
Dec 21, 2004
Messages
784
Location
Kentucky
Tractor
Mahindra 4110
...I was out pushing and clearing more brush yesterday and in the middle of the bramble was a downed 6" tree. The edge of the tree's limb must have caught the level indicator rod on the bucket and bent it without my noticing it. When I went to curl the bucket I bent the rod nearly double. I figure the easiest way to get it fixed would be to just get a metal rod and have it welded on and paint it red. The only problem is that the rod is in such poor condition I don't think I can get an accurate measure. Can anyone help me out by giving me the measure of the length of the rod?
 
   / Need some 4110 assistance... #2  
Seems to me, the only measurement you need is the diameter of the rod. Put the loader down, bucket flat on the ground and take a measurement from the spot the rod hits the bucket to the top of the indicator tube. Buy some rod several inches long, install on the bucket and cut it off where it sticks out of the indicator tube.

Simple!
 
   / Need some 4110 assistance... #3  
Keith,

I did the same thing a while back, not sure if I bent mine as bad as you describe. My solution was to take the level indicator assembly off the loader, pull the rod out, and bend it straight using the toothbar on the bucket as leverage!! Worked great for me and you can hardly tell it was ever bent. Those things do stick out in a vulnerable position.

Basically I just had to remove the 2 bolts that hold it on, bend it straight, and put back on. Took about 15 minutes..

Yours might be bent beyond repair though based on your description.
 
   / Need some 4110 assistance...
  • Thread Starter
#4  
</font><font color="blue" class="small">( Keith,

I did the same thing a while back, not sure if I bent mine as bad as you describe. My solution was to take the level indicator assembly off the loader, pull the rod out, and bend it straight using the toothbar on the bucket as leverage!! Worked great for me and you can hardly tell it was ever bent. Those things do stick out in a vulnerable position.

Basically I just had to remove the 2 bolts that hold it on, bend it straight, and put back on. Took about 15 minutes..

Yours might be bent beyond repair though based on your description.

)</font>

I don't think I can straighten mine enough to put it back in service.
 

Tractor & Equipment Auctions

2012 GENIE GTH1056 TELEHANDLER (A50854)
2012 GENIE GTH1056...
2017 Ford F-450 Crew Cab Knapheide Service Truck (A49461)
2017 Ford F-450...
2016 Nissan Frontier Ext. Cab Pickup Truck (A50323)
2016 Nissan...
Toyota 6FGU25 Forklift  5,000 lb Capacity (A51039)
Toyota 6FGU25...
2011 IC Corporation PB105 School Bus (A49461)
2011 IC...
2018 FREIGHTLINER CASCADIA (A50854)
2018 FREIGHTLINER...
 
Top