I have a 278 Bush Hog mower and exploded the U joint and sprung tractor yoke. Dealer with parts manual pulled out a yoke but it didn't match what I had, so maybe pto shaft was replaced. I finally found a yoke at Tractor Supply but after 9 stops I can't find the U joint. Yoke I got is metric. My imperial (inch) measurements of the U joint: cap diameter is 1.06 and width across is 2.94. Is there an internet source that I take the dimensions to and get a joint? Thanks.
Need to Identify U joint
- Thread starter Believer
- Start date
- Views: 1894
Farmerford
Platinum Member
- Joined
- Dec 9, 2006
- Messages
- 733
- Location
- Columbus, Georgia
- Tractor
- Kuborta B2400, L2900, L4330; Caterpillar D3B, John Deere 455D
Baum Hydraulics
Look at pto section of catalog.
not user friendly, but exhaustive
Look at pto section of catalog.
not user friendly, but exhaustive
sweettractors
Advertiser
Give me the Metric ID of the hole in your yoke and how wide across the outside of the yoke. What configuration is your tubing, egg shaped, triangular, square, rectangular or splined? The 1.060 don't work for me. Ken Sweet
sweettractors
Advertiser
I have that U-Joint in stock, Call me if you need it. We are open Labor Day 8-5-CST. Ken Sweet
