gobbler
Silver Member
First off I want to thank you guys and your vast knowledge. I recently replaced an old JD L&G with a new BX1800.
My question is about the 3pt. When it was delievered, it had my Woods GTO40 tiller attached. Since the first activity was mowing, I removed the tiller. No problems.. Went to put the tiller back on and had a bugger of a time. Seems like the rotating balls (not sure of the correct tractorspeak ) are frozen. I placed a pin in and tapped them with a hammer. Still tight. Put some grease and tapped again, still tight, but better. I guess they'll eventually loosen up.
Now, in another thread I discovered, someone mention cleaning the balls w/ paint thinner then shooting them / WD40. Sounds like a great idea.
Should I have used grease on the balls, it sure attracts alot of dirt and grit, or some other lubricant.
My question is about the 3pt. When it was delievered, it had my Woods GTO40 tiller attached. Since the first activity was mowing, I removed the tiller. No problems.. Went to put the tiller back on and had a bugger of a time. Seems like the rotating balls (not sure of the correct tractorspeak ) are frozen. I placed a pin in and tapped them with a hammer. Still tight. Put some grease and tapped again, still tight, but better. I guess they'll eventually loosen up.
Now, in another thread I discovered, someone mention cleaning the balls w/ paint thinner then shooting them / WD40. Sounds like a great idea.
Should I have used grease on the balls, it sure attracts alot of dirt and grit, or some other lubricant.