Bmullins
New member
Have a 575 NH baler that cuts both knots every time. will not tie without cutting both knots.
New holland baler knot cutting
- Thread starter Bmullins
- Start date
- Views: 1171
whodat526
Veteran Member
i dont understand what the question is
Robert_in_NY
Super Member
- Joined
- Aug 1, 2001
- Messages
- 8,586
- Location
- Silver Creek, NY
- Tractor
- Case-IH Farmall 45A, Kubota M8540 Narrow, New Holland TN 65, Bobcat 331, Ford 1920, 1952 John Deere M, Allis Chalmers B, Bombardier Traxter XT, Massey Harris 81RC and a John Deere 3300 combine, Cub Cadet GT1554
His knotter is cutting the knots on the bale side of the knot is what I understand. This is a simple fix if I remember correctly but I don't recall exactly what the process is as I have been very fortunate and have not had any trouble with my knotters on my 575 so far (knock on wood). I'm sure someone on here will jump in and tell you how to adjust them or if you have your manual it should have a trouble shooting section dealing with it. My manual is at the other barn or else I would look it up. If you don't get any responses by tomorrow night I will post what I find.