The lever to my loader has come apart and I am wondering how I can put it together permanently and correctly. I don't see what keeps it from sliding off the studs. The only thing I can figure it there is a ridge on the back side of the stud that maybe I have to pound that in to get it to stay? I am attaching a picture. The stud that controls the dumping of the loader is longer and I am not worried about that one. I am more worried about the 2 shorter studs that control raising and lowering the bucket.
New Holland TC33D with 7308 Loader Lever issue
- Thread starter rsmoot
- Start date
- Views: 1035
MTGreen
Platinum Member
- Joined
- Oct 12, 2022
- Messages
- 980
- Location
- Montana, USA
- Tractor
- Deere 5220, Ford 1720, Deere Progator 2030
Maybe they were press fit at one time. You could take them apart, take the pins to your bench and try peening the ends to get them to retain the Heim joints
Leejohn
Elite Member
Are you saying the ball joints are coming off of the studs?
Yes, the slide right off.
Harry in Ky
Veteran Member
It looks to me that all of that comes apart, one piece at a time. I would remove the bolts securing the three ball joint assemblies from the handle unit. Remove each stud one at a time. slide the respective ball onto each, then spot weld a washer or something similar to the end of the stud so the ball can't come off. Then put them all back together.
A little creative thinking is in order here.
A little creative thinking is in order here.
